When matching motor characteristics to compressor requirements, one should consider factors such as voltage, phase, and duty cycle. The motor’s rated horsepower should ideally be closely matched to the compressor’s demands to ensure optimal performance.
[pdf] The drawworks reels in and reels out the drilling line. The drilling line is connected to the traveling block and hook which connect to the drill string. The drill string runs over the crown block and setup like a block and tackle pulley system.
[pdf] A flow line, used on a drilling rig, is a large diameter pipe (typically a section of casing) that is connected to the bell nipple (under the drill floor) and extends to the possum belly (on the mud tanks) and acts as a return line (for the drilling fluid as it comes out of the hole), to the mud. .
The is used to slow the flow of returning before it hits the . This enables the shale shaker to clean the. .
A stinger line is similar to a flow line, but unlike a flow line is not used to maintain circulation. The stinger line is attached to the .
Another common add on is the sample box. This is a heavy duty rubber hose that is inserted at the end of the flow line and at the other end emplaced into the sample box itself. The.
[pdf] 
