There is dirt stuck in the wind flap or other rotating parts 1. Send the minor repair station in time to remove or replace the necessary parts. 3. If you use the air duct to refuel, do not add too much fuel at a time, but you must work hard.
[pdf] To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
To connect two compressors in parallel, follow these steps: Make sure both compressors have the same voltage and phase. Install a check valve on each compressor’s discharge line to prevent backflow. Install a tee fitting on each compressor’s discharge line. Connect the two tee fittings with a pipe..
The Short Answer: The basic process involves setting up a single pressure switch system linking both compressors, using a check valve to prevent air backflow, and using suitable hoses or pipes.
[pdf] Due to the growing need for the compressed air of higher quality, the water-lubricated twin-screw compressor with water as the only liquid in the compressor has drawn much attention to produce clean air a.
[pdf] 
