How does a screw compressor work?

A screw compressor can run loaded ('pumping air') or unloaded ('idle'). The inlet/loading valve opens and closes according to air demand. The inlet valve is controlled by a solenoid valve that supplies control air to the inlet/loading valve. Check solenoid valve coil and solenoid valve operation.

How to install air compressor?

The ground is best to be smooth cement floor. The air compressor base should be placed at 0.5/1000 (mm). And there should be grooves around and on the platform, and then the oil and repairing or washing the ground. The size of the groove is decided by the user. 3. Make sure the bottom of the compressor is placed evenly on the platform, which can

How to check if a compressor is working properly?

2、 Press the "start" button, the compressor can be work according to the set mode. At this time, observe whether normal of the display panel, pressure temperature, or abnormal sound, oil leakage. If there is abnormal, stop and check immediately. 3、 When press the "stop" button, the machine will stop after finishing unloading. It is normal

How do I Reset my air compressor?

eferenc Voltage C ent Air pressure Ai xhaust te rature Oil level e controls will showa “ ower Fault” error. Press the Enter button to reset and re compressor.Storage If the machine is stopped r over three weeks: Wrap electrical equipment such as the control panel with plastic or oil paper t

How to install air compressor piping welding?

manual before machine works. Do not change the parameter which has been adjusted in the factory. 1. Before install the piping welding, move the near flammable items and prevent welding spark dropping into the air compressor. 2. The power of the air compressor supplying line must be matched with air switch, fuse and the other safety device.

How to start a compressor?

Press the \"start\" button on the panel, then the compressor will start with \"Y\" way and working with “△” way. It is strictly prohibited that the machine starts with load (exhaustion pressure shows pressure). Otherwise it will damage the electrical components because of the large starting current.