How much power does a screw air compressor have?

Nascent Machinery Company is manufacturing the screw air compressor models with power ranging from 10 hp to 500 hp (7.5 kw to 400 kw). These direct driven compressors have standard full load pressure rating from 110 psi, 125 psi, 150 psi and 175 psi, 220 psi (0.8Mpa,1.0Mpa,1.3Mpa, and 1.6Mpa). Thank you for choosing our Screw Compressor.

Why should you lubricate a screw compressor?

Environmental protection: Lubricating oil can reduce the noise caused by high-frequency compression. The oil-injected screw compressor used by our company is a double-shaft positive displacement rotary compressor. The air inlet opens at the upper end of the casing, and the exhaust outlet opens at the lower part.

How oil injected screw air compressor works?

The oil-injected screw air compressor has the characteristics of reliable running performance, few wearing parts, low vibration, low noise, and high efficiency. During the compression process, the compressor continuously sprays lubricating oil into the compression chamber and bearings by virtue of its own pressure difference.

How to start a screw compressor?

Standard screw compressor is equipped with microprocessor control panel. When compressor is at stop status, press this button to start the compressor. the compressor and activate block mode function at the same time. — Stop Button: When the compressor is at running status, press this button to stop the compressor.

How do air compressors work?

Then the air compressor will be applied with air pressure to increase the pressure in the air tank. When the air pressure reaches the value over the set unload pressure (unload pressure value), the loading magnetic valve will lose power and the release magnetic valve is applied with power to run the air compressor with load free.

How do you drain a screw compressor?

Screw compressor utilizes a pressurized fluid drain. Use the following procedure to drain and replace the compressor fluid. Press the emergency stop button and remove the right-side cabinet panel (if applicable). Check the pressure gauge reading on reservoir and wait until reservoir pressure drops to approximately 0.05Mpa (7psi).