How do you use a rock drill?

Operation Using the rock drill for the first time When the rock drill arrives from the factory, the inside of the tool is coated with heavy oil to prevent corrosion. After unpacking and installing the tool, pour a small amount of lubrication oil into the air connection and operate the tool on partial throttle to clean the interior. 4.

How to remove hydraulic cylinder from Rotary Lift?

The first step in removing the hydraulic cylinder from the rotary lift is to prepare the workspace. Make sure that the area is clear and free of any debris or obstacles that may obstruct the work. Make sure that the hydraulic lines are disconnected and the hydraulic fluid is drained from the system.

Can a cylinder be disassembled?

If necessary to disassemble a cylinder due to a damaged part such as a plunger, the cylinder should be completely disassembled and all parts inspected. When requesting information or ordering parts, refer to the cylinder and serial numbers located at the base end of the cylinder. A Major Repair Kit should be installed when rebuilding the cylinder.

How do you disassemble a oil cylinder?

Because of oil spillage and safety, we recommend draining the cylinder of oil before disassembling. Lay the cylinder horizontally with the port down and open. Rotate the last plunger so the bleeder hole is on top and open. All head nuts are secured to the plunger by a set screw. Under the set screw is a nylon slug to protect the plunger threads.

How often should a rock drill be overhauled?

Once a week (after 40 hours of operation) Carry out a basic check of all functions of the drilling equipment. Once a month (after 200 hours of operation) Send the rock drill to a workshop for inspection. The local operating conditions will determine whether or not this is a suitable interval for overhauling the drill.

How do you remove a cylinder from a lift?

Begin by removing the bolts that secure the cylinder to the lift. Once the bolts are removed, carefully remove the cylinder from the lift. Take note of the cylinder’s position and orientation for reference. Once the cylinder is removed from the lift, the next step is to clean the components. Thoroughly clean the cylinder and the surrounding area.