Drilling rig flow lines

A flow line, used on a drilling rig, is a large diameter pipe (typically a section of casing) that is connected to the bell nipple (under the drill floor) and extends to the possum belly (on the mud tanks) and acts as a return line (for the drilling fluid as it comes out of the hole), to the mud. Possum BellyThe is used to slow the flow of returning before it hits the . This enables the shale shaker to clean the cuttings out of the drilling fluid before it is returned to the pits for circulation.. . Another common add on is the sample box. This is a heavy duty rubber hose that is inserted at the end of the flow line and at the other end emplaced into the sample box itself. The sample box is used to capture sa. . A stinger line is similar to a flow line, but unlike a flow line is not used to maintain circulation. The stinger line is attached to the to allow for the pressure from a to be released. The stinger line. [pdf]

Screw air compressor failure analysis

The analysis of the cause of the failure and the solution are as follows: (1) Whether the condensed water discharged from the trap has a large oil content, if so, check the leakage point in the unit and eliminate it, check whether the oil level of the compressor is too high, if so, reduce the oil level; (2 ) Whether the opening pressure of the minimum pressure valve is normal, if so, troubleshoot, and it is necessary to replace the valve; check whether the oil return pipe is blocked, if so, clean or replace the oil return pipe: (3) Replace the oil separator core. [pdf]

Flow line drilling rig

A flow line, used on a drilling rig, is a large diameter pipe (typically a section of casing) that is connected to the bell nipple (under the drill floor) and extends to the possum belly (on the mud tanks) and acts as a return line (for the drilling fluid as it comes out of the hole), to the mud. . The is used to slow the flow of returning before it hits the . This enables the shale shaker to clean the. . A stinger line is similar to a flow line, but unlike a flow line is not used to maintain circulation. The stinger line is attached to the . Another common add on is the sample box. This is a heavy duty rubber hose that is inserted at the end of the flow line and at the other end emplaced into the sample box itself. The. [pdf]