H2S is extremely toxic to humans at minute concentrations. At higher concentrations it is flammable, as well as corrosive to metals. A surface breakout of this gas, if not responded to and controlled immediately, can result in injuries and/or fatalities, fire and explosion. If an H2S event were to occur during adverse. .
In the presence of moisture, H2S forms sulfurous and sulfuric acids, which are corrosive to metals. Corrosivity is enhanced in the. .
H2S has an immediately dangerous to life and health (IDLH) concentration of 100 ppm. For an airborne contaminant, IDLH is defined as the level of the contaminant likely to cause death. .
Employees required to use respirators must undergo a medical examination by a physician or licensed health care provider (PLHCP) in. .
A written respiratory protection program and H2S contingency plan that are developed in the planning phase for the well will ensure the safety of all rig personnel. Safety.
[pdf] Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The numbe.
[pdf] 
Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing).
[pdf] 
