Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can. .
The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. .
Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). .
The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. .
The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the.
[pdf] A common drill rig used for "Shot Hole Drilling" is the L.I.S (Low Impact Seismic) mounted on track carrier for operation in cut lines or environmentally sensitive area. Truck mounted drill or 4X4 buggy are utilized in the prairies. These drill rigs use water or air to assist the drilling.
[pdf] Directional drilling (or slant drilling) is the practice of drilling non-vertical bores. It can be broken down into four main groups: oilfield directional drilling, utility installation directional drilling, directional boring (horizontal directional drilling - HDD), and surface in seam (SIS), which horizontally intersects a vertical bore target to extract coal bed methane.. HistoryMany prerequisites enabled this suite of technologies to become productive. Probably, the first requirement was the realization that , or , do not necessarily need to be vertical. This realization. .
Wells are drilled directionally for several purposes: • Increasing the exposed section length through the reservoir by drilling through the reservoir at an angle.• Drilling into the reservoir w.
[pdf] 
