Check the isolation of the motor windings. Should be in the mage-ohms (you need an isolation tester / high voltage ohm meter for this). Check the voltage when the compressor is running. If the voltage drop significantly when the compressor starts/runs, you have a bad connection somewhere.
[pdf] Drilling and blasting are the two most significant operations in open pit mines that play a crucial role in downstream stages. While previous research has focused on optimizing these operations as two separate p.
[pdf] Before making any repairs, be sure the unit is unplugged and tank has no air. To remove the line and load cords from the pressure switch, the pressure switch cover will need to be removed. Use your Phillips head screwdriver to loosen the screw located either on the top or on the side of the cover.
[pdf] 
