The air below the deck is typically hot, humid and saline. It’s not a friendly environment, and your compressor’s build quality needs to reflect this. The process starts with the compressor sucking in air from the surroundings. It enters the air end, which houses the screws. Oil is injected, acting as a lubricant. .
The screws push the air into an oil separator receiver. This unit consists of two stages: 1. High-efficiency cyclone separator 2. Oil. .
Having passed through the filter, the air is ready for some cooling. The non-return discharge valve, which only opens at a minimum positive pressure, lets the air through in appropriate measures. To cool down the compressed air to a level that will be acceptable for. .
A marine air compressor needs a proper water separator. By proper, we mean a cyclone separator with level-controlled drainage. The conventional approach is to use a solenoid valve on a timer. It opens up on regular intervals, causing pressure from the compressor.
[pdf] Air compressor oil is standard or synthetic oil made specifically for air compressors. Unlike motor oil, air compressor oil does not contain detergent and typically has lower amounts of carbon, sulfur, an.
[pdf] 
We will start our trip through the loop at the same place we will finish: The oil sump. This reservoir is where oil is stored for use in the system. It is usually located in the lower section of a tank-like cylinder, that also houses components used in the air/oil separation. .
Oil from the sump flows through small entry passages around the outside of the filter base and is forced through an opening near the closed side of the filter casing, where it. .
Our next stop, assuming our lubricant has reached its operating temperature will be to the oil cooler. As our lubricant has been subjected to extreme friction and bears the brunt of temperature. .
This is our first stop in our trip through the system. This valve will direct our lubricant towards its next component based on temperature. Just. .
This component, like the radiator in your car, passes the fluid through tubing encased in a block of baffles, designed to optimize heat transfer. Most air-cooled air compressors have a high capacity fan which will force air through the baffles, and out of the cabinet,.
[pdf] 
