Use your Phillips head screwdriver to loosen the screw located either on the top or on the side of the cover. Unhook all of the black and white wires from the pressure switch using the needle nose pliers. Take a 5/16” nut driver and remove the ground screws, holding down the ground wires.
[pdf] DTH technique was used in well drilling exclusively to dig, accurate, vertical bores, and rotary drilling was used to turn the hole. The Directional DTH system, patented by Atlas Copco, was first used.
[pdf] Fasten head end of cylinder to cylinder service stand. 2. Remove line (B). 3. Pull rod out so piston is against rod guide. 4. Connect rod to a hoist using a lifting strap. 5. Remove cap screws (A). 6. Pull rod, rod guide and piston from barrel.
[pdf] 
