Use your Phillips head screwdriver to loosen the screw located either on the top or on the side of the cover. Unhook all of the black and white wires from the pressure switch using the needle nose pliers. Take a 5/16” nut driver and remove the ground screws, holding down the ground wires.
[pdf] Solutions: Inspect the system for leaks, replace clogged filters, and check for worn parts like seals or rotors. Possible Causes: Loose components, bearing wear, or improper alignment. Solutions: Tighten loose components, inspect bearings, and ensure proper alignment of moving parts.
[pdf] Checkout Current Transformers (CTs) and check resistance across each one while it is disconnected. All resistances should be within 10% of one another. Also do a diode test on the CT inputs on each compressor module. (The diode test is described in RTAA-SVB10B-EN.)
[pdf] 
