This Best Practice provides guidance for improving safety when working around drilled holes on distribution and transmission projects. Operating Units have the responsibility to put in place those measures tha.
[pdf] You need to remove the "T" or "L" connector from the top of the nozzles bulkhead assy. Press down on the bulkhead's collet, while pulling on the "T" connector to safely remove. Then remove the top nut off the bulk head. Now take your nozzle and insert it up and through the hole in the cage corner.
[pdf] 
In the oil and gas industry, depth in a well is the distance along a well between a point of interest and a reference point or surface. It is the most common method of reference for locations in the well, and therefore, in oil industry speech, "depth" also refers to the location itself. Strictly, depth is a vertical coordinate. .
Although it is an intuitive concept, depth in a well is the source of much confusion because it is frequently not specified correctly. Absolute depth should always be specified with three components:• a. .
Specification of an absolute depth: in Figure 1 above, point P1 might be at 3207 mMDRT and 2370 mTVDMSL, while point P2 might be at 2530 mMDRT and 2502 mTVDLAT.. .
• • • Log Data Acquisition and Quality Control, Ph. Theys, 1991, Editions Technip .
• Well depth values taken during the drilling operation are referred to as "". The "total depth" for the well, core depths and. .
• Unit: the usual unit of depth is the metre (m).• Path: common expressions of path are measured depth (MD) – elsewhere often known as along hole depth (AHD) – and true vertical depth (TVD). Note that using TV for true vertical.
[pdf] 
