Rigid drill chuck removal

 Insert a 5/16 in. or larger hex key into the chuck of the drill and tighten the chuck jaws securely.  Tap the hex key sharply with a mallet in a clockwise di- rection. This will loosen the screw in the chuck for easy removal.  Open the chuck jaws and remove the hex key. [pdf]

The drill rod of the down-the-hole drill is unstable

Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation.. Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation.. Before drilling, inspect the condition and lubrication of all drill string components, including the hammer or drifter. Replace any worn out parts, following manufacturer’s recommended discard limits closely. Snake skin is a wear pattern of micro cracks that develop from drilling fatigue in non-abrasive rock.. This chapter contains some common types of failures occurring on DTH drilling tools For most failures we can identify it’s probable cause and typical supporting evidence. Rod connection and removal are crucial aspects of down-the-hole drill operations, directly impacting overall work efficiency and the service life of rock drilling tools.. It was possible that the rig was drilling in severe drilling conditions, or that the driller was pushing too hard or had a poor drill string design. I asked some questions as to hole sizes, depths, etc. [pdf]

Down-the-hole drill installation and debugging video

A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic. [pdf]

FAQS about Down-the-hole drill installation and debugging video

What is a down-the-hole drill?

A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one of the fastest ways to drill hard rock.

What is down-the-hole (DTH) drilling?

Down-the-hole (DTH) drilling has made it easier for contractors to drill wells faster and more efficiently, and to transition from dirt boring to rock boring just by adding a compressor and hammer to the drill bit.

How does DTH drilling work?

With DTH drilling, contractors can change the drill that they were using for the current directional bore to a rock drill when they encounter rock by connecting the drill with a compressor and a steerable hammer. Well drilling also needed changes to be made to rotary drilling when the well needed to take a turn.

How does DTH hammer drilling work?

A flushing current conveys the loosened drill cuttings upwards and exits at the upper end of the casing. If you have any further questions, please contact our local sales or service team. DTH hammer drilling is a percussive drilling process powered by compressed air.

What is a DTH drill?

DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole.

How do you drill a rock with a DTH hammer?

This method is mainly applied for hard to very hard rock and/or for penetrating large boulders. 1. Setting the DTH hammer with drill rod and casing on the drilling point. 2. Rotary and percussive drilling of the drill string under compressed air supply. 3. After reaching the final depth, unlocking of the drill rod with DTH hammer and pilot bit.