Turn the throttle lever gradually and drill at a slow speed until the hole is collared. The drill should be kept at right angles to the work until the hole is collared, then repositioned for angle drilling. Always apply sufficient down pressure to keep the tool from bouncing.
[pdf] Each screw machine must be equipped with a gas storage tank and, if needed, auxiliary equipment such as a cold dryer and a filter. The installation requirements are as follows: A) The installation sequence of supporting equipment is: “air compressor → gas tank → gas-water separator → cold dryer.”
[pdf] Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The numbe.
[pdf] 
