Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Before drilling, inspect the condition and lubrication of all drill string components, including the hammer or drifter. Replace any worn out parts, following manufacturer’s recommended discard limits closely. Snake skin is a wear pattern of micro cracks that develop from drilling fatigue in non-abrasive rock..
This chapter contains some common types of failures occurring on DTH drilling tools For most failures we can identify it’s probable cause and typical supporting evidence.
Rod connection and removal are crucial aspects of down-the-hole drill operations, directly impacting overall work efficiency and the service life of rock drilling tools..
It was possible that the rig was drilling in severe drilling conditions, or that the driller was pushing too hard or had a poor drill string design. I asked some questions as to hole sizes, depths, etc.
[pdf] The first step is to ensure that the hydraulic system is shut down and the pressure is relieved. Then, the cylinder should be disconnected from the hydraulic system and the cylinder head should be removed. Once the cylinder head has been removed, the piston rod can be manually retracted by hand.
[pdf] Before starting casing, the drilling supervisor should hold a pre-job safety meeting and confirm the following with the crew: 1. Remove unnecessary tools. 2. Good Housekeeping before the job 3. Rig up Casing handling equipment: Using appropriate hand. .
A circulation sub, fitting the casing thread, equipped with a WECO connection, shall be readily available on the rig floor at all times during casing running.
[pdf] 
