Install the drill rod and bit, and connect the air and water hoses. Place the air leg in a stable position and adjust the angle of the rock drill. Turn on the air and water supply, start the rock drill, and begin drilling.
[pdf] Turn the throttle lever gradually and drill at a slow speed until the hole is collared. The drill should be kept at right angles to the work until the hole is collared, then repositioned for angle drilling. Always apply sufficient down pressure to keep the tool from bouncing.
[pdf] The results of the experimental study for the compressive strength and the abrasivity of the rock samples are given in Table 1. It is seen that, with increase in compressive strength abrasivity of rock samples also increases. This may be attributed to increase in the resistance of rocks to wear with increase in the. .
Regression analysis is the statistical methodology for predicting values of one or more dependent variables from a collection of (independent) variables.. .
The coefficient of correlation between the measured and predicted values is a good indicator to check the prediction performance of the model. In this study, values.
[pdf] 
