Horizontal shale drilling rig equipment components

Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. . The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. . The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. . The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. . Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). [pdf]

Oil rig drills into salt mine video

In , the formation of a often pushes terrain upward from the surrounding land, while also creating a subterranean , holding petroleum deposits. On Thursday, November 20, 1980, the drill assembly of a contracted , just offshore of the salt dome-caused Jefferson Island (itself in the east southeast section of Lake Peigneur), pierced an inactive third level of the . The hole produce. [pdf]

FAQS about Oil rig drills into salt mine video

Why did 12 men abandon their oil drilling rig?

Early in the morning on November 20, 1980, twelve men decided to abandon their oil drilling rig on the suspicion that it was beginning to collapse beneath them. They had been probing for oil under the floor of Lake Peigneur when their drill suddenly seized up at about 1,230 feet below the muddy surface, and they were unable to free it.

Did a drill crew Penetrate the salt dome?

Clearly, the salt dome which contained the mine had been penetrated by the drill crew on the lake.

What happened at the bottom of a ruined salt mine?

Trapped air geisered upped hundreds of feet high, some of the swallowed barges floated back up to the surface, but the oil rigs, buildings, salt-filled barges, and other equipment are still at the bottom of a ruined salt mine. The experience gave Richard nightmares for years.

Different parts of a drilling rig

Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. . The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. . The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. . The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. . Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). . • (#22) is a section of large diameter pipe fitted to the top of the that the attaches to via a side outlet, to allow the to flow back to the .• (BOPs) (#23 and #24) are devices installed at the wellhead to prevent fluids and gases from unintentionally escaping from the . #23 is the annular (often referred to as Hydril named after a manufacturer), and #24 is the pipe rams and blind rams. [pdf]