Air compressor designed to take fully into account the safety of operators, but operators must ultimately be responsible for their own safety. Below the security measures only as a guidance, is aimed at the use of air compressor in the process of harm reduction. Not. .
If the air compressor within the very large space (to accommodate), in the air compressor to work outside the marked, and must cut off power and placed obvious signs. .
Work long hours in the air compressor next to the operators must wear ear protectors. .
Avoid physical and thermal fluid, heat and the exhaust pipe of contact with the surface, to avoid scalding. Key tasks include changing oil and filters, cleaning air filters and cooling systems, inspecting motors and wiring, and ensuring proper operation of key components. Daily maintenance should focus on cleaning, monitoring performance, and adjusting load.
[pdf] DTH hammersare most used in hard rock formations and are designed to tackle complex tasks like drilling in populated areas without putting existing structures at risk. In these areas, they are ideal for drilling larg.
[pdf] 
DTH is short for “down-the-hole”. Since the DTH method was originally developed to drill large-diameter holes downwards in surface-drilling applications, its name originated from the fact that the percussion mechanism followed the bit down into the hole. Applications were later found for the DTH method. .
A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a. .
A is first thought to have been used for rock drilling in 1844. Many quarries used hand held tools that required the driller to suspend himself from a rope over the. .
In DTH drilling, the percussion mechanism – commonly called the hammer – is located directly above the drill bit. The drill pipes transmit the necessary feed force and rotation to the hammer and the bit, along with the fluid (air, water or drilling mud) used to. .
DTH products can be used in the following applications:• Mining- drill and blast holes in open pit mining, where the drill operator will drill several holes, then. In down-the-hole drilling a drill rod is fitted with a hammer at its lower end. The hammer, which is mounted on the drill bit, is activated through the addition of compressed air and driven into the ground – simultaneously rotating and impacting.
[pdf] 
