A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic.
[pdf] They are used to keep the pressure in a tank between a pre-set lower and upper pressure. When the tank pressure crosses the upper or lower limit, an electrical switch is operated. Normally Closed (NC) switch.
[pdf] When matching motor characteristics to compressor requirements, one should consider factors such as voltage, phase, and duty cycle. The motor’s rated horsepower should ideally be closely matched to the compressor’s demands to ensure optimal performance.
[pdf] 
