Songa delta drilling rig

Songa Offshore AS was founded in January 2005 with the purchase of the two semisubmersibles, Mata Redonda and La Muralla. Mata Redonda was renamed Songa Venus and La Muralla was renamed . On August 15, 2017, announced it was acquiring Songa Offshore for US$1.2 billion in cash, and an enterprise value of approximately US$3.4 billion. The complete transfer of business to Transocean was done by Ja. . Songa Offshore operates seven oil rigs. • Songa Dee• Songa Delta• Songa Trym• Songa Equinox (Cat D-1). [pdf]

FAQS about Songa delta drilling rig

Who owns Songa oil rigs?

Songa Offshore operates seven semi-submersibles oil rigs. In 2014, Songa Offshore sold Songa Venus and Songa Mercur rigs to Opus Offshore as a part of the deal creating Songa-Opus joint venture Songa Opus Offshore Drilling Pte Ltd (SOOD) that incorporates Songa's international operations. Ordered Cat D rigs were delivered in 2015.

Which rigs operate from Norway?

At present each of the three rigs operating from Norway are engaged on long-term contracts. Songa Dee is working on a five year contract with Statoil on the Gullfaks field, whilst Songa Trym is also employed by Statoil for the Troll field, and Songa Delta is contracted with Det Norske.

Who are Songa Dee & Songa Delta?

Songa Dee is working on a five year contract with Statoil on the Gullfaks field, whilst Songa Trym is also employed by Statoil for the Troll field, and Songa Delta is contracted with Det Norske. Both Songa Trym and Songa Delta are currently being externally managed but will be taken back over by Songa Offshore in mid 2012.

Run casing drilling rig

Before starting casing, the drilling supervisor should hold a pre-job safety meeting and confirm the following with the crew: 1. Remove unnecessary tools. 2. Good Housekeeping before the job 3. Rig up Casing handling equipment: Using appropriate hand. . A circulation sub, fitting the casing thread, equipped with a WECO connection, shall be readily available on the rig floor at all times during casing running. [pdf]

Different parts of a drilling rig

Drilling derricks and Rig Masts consist of a steel framework with a square or rectangular cross-section. Their purpose is to support the hoisting equipment and rack the tubulars while tripping pipe. The number of joints in a stand (single-double-triple) that the rig can pull is dependent on the height of the derrick. . The Drawworks is one of the most important components of the drilling rig (types of drilling rigs). The unit supplies the hoisting power, the. . The Crown Blockas a drilling rig component is a fixed set of pulleys (called sheaves) located at the top of the derrick or mast, where the drilling line is threaded. The companion blocks to these pulleys are the traveling blocks. By using two sets of blocks in this fashion,. . The Traveling Blockis a set of sheaves (pulleys) that move up and down in the derrick. The drilling line is threaded (reeved) over the. . Attached to the bottom of the traveling blocks, the hook is required to hang the swivel and rig kelly(for drilling) and the elevator bales (for tripping pipe and casing). . • (#22) is a section of large diameter pipe fitted to the top of the that the attaches to via a side outlet, to allow the to flow back to the .• (BOPs) (#23 and #24) are devices installed at the wellhead to prevent fluids and gases from unintentionally escaping from the . #23 is the annular (often referred to as Hydril named after a manufacturer), and #24 is the pipe rams and blind rams. [pdf]