Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Frequent rotation in the directional well forms a keyway, and the drill rod is stuck in the keyway. Preventive measures: Regularly perform short trips to repair the wellbore and control dogleg deviation..
Before drilling, inspect the condition and lubrication of all drill string components, including the hammer or drifter. Replace any worn out parts, following manufacturer’s recommended discard limits closely. Snake skin is a wear pattern of micro cracks that develop from drilling fatigue in non-abrasive rock..
This chapter contains some common types of failures occurring on DTH drilling tools For most failures we can identify it’s probable cause and typical supporting evidence.
Rod connection and removal are crucial aspects of down-the-hole drill operations, directly impacting overall work efficiency and the service life of rock drilling tools..
It was possible that the rig was drilling in severe drilling conditions, or that the driller was pushing too hard or had a poor drill string design. I asked some questions as to hole sizes, depths, etc.
[pdf] The first step is to ensure that the hydraulic system is shut down and the pressure is relieved. Then, the cylinder should be disconnected from the hydraulic system and the cylinder head should be removed. Once the cylinder head has been removed, the piston rod can be manually retracted by hand.
[pdf] Each screw machine must be equipped with a gas storage tank and, if needed, auxiliary equipment such as a cold dryer and a filter. The installation requirements are as follows: A) The installation sequence of supporting equipment is: “air compressor → gas tank → gas-water separator → cold dryer.”
[pdf] 
