Fill the oil reservoir with proper oil (Air Tool oil or 10W grade equivalent for 9 lb.and 15 lb.class and Rock Drill oil for the 38 lb.and 60 lb.class.) Check all nuts and bolts to ensure they are tight on the tool. Make sure retainer locks in place. Replace retainer and or springs if worn.
[pdf] The waste hot recovery equipment introduces high-temperature circulating oil and high-temperature compressed air into the heat water unit. The heat generated during the operation of the air compressor is fully absorbed by the water heater. And the compressor can be cooled down at the same time.
[pdf] This can be done by wiping it down with a dry cloth and then spraying the cloth with compressed air to remove any debris on the surface. If there are stubborn stains or dirt, you may need to use some type of cleaners like soap and water or wax and grease remover.
[pdf] 
