A cutting process that involves spinning a drill bit to create a circular hole in solid materials is known as drilling. The drill bit is typically a multi-point rotary cutting tool. The bit is pressed against the workpiece and rotated at speeds between several hundred and several thousand revolutions per minute. This. .
A high-precision hole-finishing procedure carried out with a multi-edge tool is known as reaming. High penetration rates and shallow cuts involved in the reaming process enable close. .
A cutting process that entails enlarging an existing hole in a workpiece with a single-point cutting tool or boring head is known as boring.. .
The process of enlarging one end of the hole giving it a conical shape is called countersinking. Countersinking creates a V-shaped edge near the hole's surface. It is frequently employed for deburring drilled or tapped holes, and to ensure fasteners sit tightly in the. .
The process of enlarging a hole over a particular section in the workpiece for screw clearance using counterboring tools is known as counterboring. This creates a shallow and enlarged.
[pdf] The hydraulic system is the muscle of the crawler mounted drill rig, and its control is a vital part of the overall control system. Hydraulic valves are used to direct the flow of hydraulic fluid to different actuators, such as cylinders and motors.
[pdf] A flow line, used on a drilling rig, is a large diameter pipe (typically a section of casing) that is connected to the bell nipple (under the drill floor) and extends to the possum belly (on the mud tanks) and acts as a return line (for the drilling fluid as it comes out of the hole), to the mud. .
The is used to slow the flow of returning before it hits the . This enables the shale shaker to clean the. .
A stinger line is similar to a flow line, but unlike a flow line is not used to maintain circulation. The stinger line is attached to the .
Another common add on is the sample box. This is a heavy duty rubber hose that is inserted at the end of the flow line and at the other end emplaced into the sample box itself. The.
[pdf] 
