The GSF Arctic III drilling rig is owned by GlobalSantaFe which can be contacted for jobs and careers on the GSF Arctic III. The Semisub is a Semisub type of rig and is designed as a Friede & Goldman L-907 Enhanced Pacesetter and built by Rauma Repola Oy at the Rauma Repola Finland shipyard.
[pdf] 
Drill pipe elevators for USC with taper shoulder and square shoulder weld-on tool joints shall have bore dimensions as specified in Table 1. Notes on Table 1: Oilfield elevators with identical bores are the same. 1. * Not Manufactured. 2. ** Obsolescent connection. 1. 1 Dimension DTE from API Spec. 7, Table 4.2 2. 2. .
A very close fit of the hinge pin and pawl significantly affects the correct functioning of an elevator – especially the center-latch elevator. If there is play in the hinge, the elevator tends to. .
In addition to the side-door elevator, single-joint and slip-type casings are used in running casing. We use a single-joint elevator (Figure 7) to. .
Since both care and inspection procedures depend primarily upon the amount of service the equipment has had, it is challenging to project. .
The following checks apply to all types of elevators. For a quick reference to critical points of the drill pipe elevators, see Figure 29. 1. Is the oilfield elevator size correct? 2. Are the dies of slip-type elevators sharp? 3. Are the hinge pin or holes worn? 4. Are.
[pdf] Federal and state authorities are investigating the cause of the deadly explosion and fire at a natural gas drilling rig in southeastern Oklahoma on Monday. Five workers died in what appears to be one of the country’s deadliest onshore drilling accidents.
[pdf] 
